Electrical power UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE one
Common Description
This electrical power unit is created exclusively for that modest lift table,Consisting of substantial stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit is broadly applied in the industry of logistic units which include minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is controlled from the solenoid valve with all the speed controlled by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Basic Description
This power unit is created solely for your medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve and also the speed controlled by the adjustable needle valve. Once the lift rises to a substantial positoin, however the energy provide is minimize, the lowering movement is controlled by the guide override perform.
Electrical power UNITS FOR LIFT TABLE 3
General Description
This power unit is created exclusively for the huge lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve plus the speed controlled by a strain compensated flow handle valve.
Power UNITS FOR LIFT TABLE four
General Description
This energy unit is designed exclusively for the huge lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve along with the pace managed by the adjustable needle valve. When the lift rises to a higher positoin, but the energy provide is cut, the lowering motion is managed by the manual override perform.
Distinctive Notes
one. This energy unit is of S3 duty cycle, which can only function intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all the hydraulic components concerned prior to set up of the power unit.
3. Viscosity in the oil shoud be 15~46 cst,which ought to also be clean and totally free of impurities.N46 hydraulic oil is recommended.
four. Oil changing is needed immediately after the preliminary 100 operation hrs,afterwards as soon as every 3000 hours.
five. The power unit shown is designed to be mounted vertically.